Rings

P&I manufactures brazing rings to customer-defined specifications. Our rings help provide accurate braze volume control and improve consistency during the joining process, yielding a higher-quality braze joint while reducing alloy consumption. Our manufacturing capabilities allow us to produce many ring types, ensuring more efficient and higher-quality braze joints.

Request A Quote

Rings

ID Butt-End Braze Ring with Slight Helix Most common ring. Made with an undersized ID which will cling fit onto the OD of a part. Helix is usually equal to half of the wire DIA.
ID Butt-End Braze Ring without Helix Common ring. Made with an undersized ID which will cling fit onto the OD of a part. Typical dimensions: 0.500 ID X 0.035 X 0.015 Max Gap, No Helix
ID or OD Multi-Turn Braze Ring These can be produced in a range from a slight overlap to multiple turns. Typical dimensions: 0.500 ID X 0.035 X 0.015 Max Gap.
OD Gap Braze Ring Common ring for inserting a ring into the ID of a brazed part. The ring is made with an over-sized OD and gap which are both compressed to have a compression fit into the ID of the base part. Typical dimensions: 0.500 OD X 0.035 X 0.040-0.030 Gap.
ID Segment Braze Ring These rings can be used for applications where the joint is less than 360. Typical dimensions 0.500 ID X 0.035 X 0.015 Max Gap.
ID Band Braze Ring A ring made from flattened wire. Often used to increase volume of preform where increased wire diameter won't work. Also used to place 1 preform instead of 2. ID Typical dimensions: 0.500 ID X 0.020 X 0.050 BAND-RING X 0.015 Max Gap.
Edgewound A ring made from flattened wire, but with the smaller surface on the ID & OD. Can be a cheaper alternative to a washer. Edgewounds have a slight helix. Typical dimension: 0.500 ID X 0.020 X 0.050 EDGEWOUND X 0.015 Max Gap.
ID Braze Ring - Square Wire A ring made from wire with a square cross section. Typical dimensions: 0.500 ID X 0.030 SQUARE X 0.015 Max Gap