Shop our platinum and platinum-iridium marker band inventory online at pimedicalstore.com
View AS9100 Cert | View ISO 13485:2019 (Limited Scope) Cert

Brazing Rings

Prince & Izant designs and manufactures brazing rings for customer-defined specifications. Our rings help to provide accurate control over braze volume and improve the overall consistency during the joining process. Our manufacturing capabilities allow us to produce a multitude of ring types ensuring more efficient and higher quality braze joints.

ID Butt-End Ring with Slight Helix

ID Butt-End Braze Ring with Slight Helix

Most common ring. Made with an undersized ID which will cling fit onto the OD of a part. Helix is usually equal to half of the wire DIA.
ID Butt-End Ring without Helix

ID Butt-End Braze Ring without Helix

Common ring. Made with an undersized ID which will cling fit onto the OD of a part. Typical dimensions: 0.500 ID X 0.035 X 0.015 Max Gap, No Helix
ID or OD Multi-Turn Ring

ID or OD Multi-Turn Braze Ring

These can be produced in a range from a slight overlap to multiple turns. Typical dimensions: 0.500 ID X 0.035 X 0.015 Max Gap.
OD Gap Ring

OD Gap Braze Ring

Common ring for inserting a ring into the ID of a brazed part. The ring is made with an over-sized OD and gap which are both compressed to have a compression fit into the ID of the base part. Typical dimensions: 0.500 OD X 0.035 X 0.040-0.030 Gap.
ID Segment Ring

ID Segment Braze Ring

These rings can be used for applications where the joint is less than 360. Typical dimensions 0.500 ID X 0.035 X 0.015 Max Gap.
ID Band Ring

ID Band Braze Ring

A ring made from flattened wire. Often used to increase volume of preform where increased wire diameter won't work. Also used to place 1 preform instead of 2. ID Typical dimensions: 0.500 ID X 0.020 X 0.050 BAND-RING X 0.015 Max Gap.
Edgewound Ring

Edgewound

A ring made from flattened wire, but with the smaller surface on the ID & OD. Can be a cheaper alternative to a washer. Edgewounds have a slight helix. Typical dimension: 0.500 ID X 0.020 X 0.050 EDGEWOUND X 0.015 Max Gap.
ID Ring with Square Wire

ID Braze Ring - Square Wire

A ring made from wire with a square cross section. Typical dimensions: 0.500 ID X 0.030 SQUARE X 0.015 Max Gap.
Gold
Silver
Platinum
Palladium
Request a Quote Now!